Used to replicate an element at a
specified distance from the original.
You can access this tool from the following:
- Ribbon:
Civil >
Horizontal >
Offsets and Tapers split button
Use the Single Offset Entire Element tool to replicate an
element at a specified distance from the original.
-
Open the Horizontal Geometry section then click the
Single Offset Entire Element icon.
-
When you move the cursor into the View, the command
prompt requests that you "Locate Element", so data point, example, left-click
on the element that you wish duplicate.
-
Use one of the following methods to set the offset:
-
As you move the cursor, a value is displayed.
Data point at the desired value.
-
Enter a value and strike the Enter key then data
point.